Hydraulic tube fittings can not be used to replace ordinary dedicated connector

Hydraulic tube fittings in the hydraulic system, the connecting member and the pressure tubing pressure tubing between. Hydraulic tube fittings can not be used to replace ordinary dedicated connector, because the hydraulic are can withstand a lot of stress. In the hydraulic system, either a metal hydraulic tube fittings, hoses or fittings, are prone to leakage problems. For card sets of pipe joints, mostly due to the pipeline by a hydraulic tube fittings  force or impact, so that the card sleeve loose or pipe end surface deformation caused by leaks, you should check whether the card sets out of round, edge or without defects, whether the pipe ends in good condition and the extent of compression ferrule nut, but also eliminate the pipeline force. For Hydraulic tube fittings tube hydraulic tube fitting, mostly due to excessive flaring, substandard quality requirements or repeatedly demolished, resulting in flaring deformation or cracks caused by leaks, then you can be re-flared front amputated. If you use a male and female cone top pressure seal, which is mostly due to the two cone leak damage, is available on the cone grinders for grinding. For use oil sheet, wool felt, soft steel board, combination gasket sealant joints or pipe leaks, no matter what the material is, you should first check the seals for damage, deformation, aging and rough through the large, etc. and then take the appropriate measures.