Shrink cable joint processing preventive measures and treatment

After stripping the cable insulation , the main application of fine sandpaper carefully polished surface of the insulation layer , making it smooth and no marks, no semiconductor residual points . The insulation must be cleaned with a cleaning solvent shield direction from the core to the semiconductor , do not use the shield layer in contact with the semiconductor cleaning paper to clean the main insulation layer on the surface .After crimping wire core , application file, sandpaper carefully polished to eliminate edges and tip , and pay attention to metallic particles may not remain on the surface of the insulating layer .Special attention should be in the process of making the cable connector to keep clean , and should try to shorten production time , after stripping the cable cut , exposed in the air longer, the possibility of invasion of impurities , water , gas , dust, etc. , the greater , thus impact of joint quality . Therefore required before construction to do all the preparatory work to ensure the production of non-stop , go.
    Before making hydraulic hose fittingto carefully check the cable accessories and cable facilities, so as to strictly control the amount of interference shrink silicone rubber insulating sleeve , to ensure that they have sufficient grip force , close contact with the interface , there is no gap .
    Semiconductor adhesive tape were wrapped in shrink after each phase of silicone rubber composite insulating sleeve two port. Thus , both the silicone rubber outer casing outside the semiconductor layer and semiconductor XLPE cable shield good contact , but also play a role in the axial waterproof .
    Surrounding the self-adhesive waterproof tape, shrink Hydraulic pipe fittings seal is proof key to a semi- joint overlap method from one end to the other end wrapped and then wrapped in the opposite direction from one end to the starting side, wrapped in two layers. After each wrapped with both hands clasped in turn again, to make it better bonding. Be sure to pull when properly wrapped , so tightly wrapped seamless .