The use of the size of the high-pressure hose

In the high-pressure hose for withholding, you always will have withheld too tight or too loose phenomenon, and these phenomena often lead to an adverse effect on high-pressure hose. Today we say that it would withhold the amount of the size of what impact Hydraulic pipe fittings. We carried out through the following detailed understanding.High pressure hose and fittings assembly and withhold the amount of the withholding rate of improper selection or joint structure and material, size selection is unreasonable, can lead to high pressure hose and fittings withholding too tight or too loose, the joints can cause early damage.Assembly, if the withholding amount is too small, the high pressure hose between the connector and the weight is too loose, the role of the hydraulic pressure hose during the initial period there may emerge from the connector; if withholding excessive, fittings and hose too tight, easily lead to localized damage the hose inner being, cracks, pressure oil from the ruptured directly into the wire layer, and then he went along the gap between the wire coat tail spray, or until he went somewhere along the wire layer build up, so thatHydraulic adapters drum kits produced even rupture. Hose and connectors in the assembly, if the withholding too fast, easy to cause damage to the inner rubber layer and wire breakage, so that premature failure of the hose in use.The above information is very detailed description of the size of the amount withheld for the use of high pressure hose impact, so we should use this withholding considerable attention, he dosage size is accurate, whether the mutation will produce high pressure hose, etc. issues that should be close attention.